EXF-RC15 Installation Guide
Unitronics
2
Before using this product, the user must read and understand this document.
All examples and diagrams are intended to aid understanding, and do not guarantee operation.
Unitronics accepts no responsibility for actual use of this product based on these examples.
Please dispose of this product according to local and national standards and regulations.
Only qualified service personnel should open this device or carry out repairs.
Failure to comply with appropriate safety guidelines can cause severe injury or property damage.
Do not attempt to use this device with parameters that exceed permissible levels.
Do not connect/disconnect the device when power is on.
Environmental Considerations
Do not install in areas with: excessive or conductive dust, corrosive or flammable gas,
moisture or rain, excessive heat, regular impact shocks or excessive vibration, in accordance
with the standards given in the product’s technical specification sheet.
Do not place in water or let water leak onto the model.
Do not allow debris to fall inside the model during installation.
Ventilation: 10mm space required between model
’s top/bottom edges & enclosure walls.
Install at maximum distance from high-voltage cables and power equipment.
DIN-rail Mounting
1. Snap the model onto the DIN rail as shown in
the figure to the right.
2. When properly mounted, the model is squarely
situated on the DIN-rail as shown in the figure
to the right.
Setting the Unit ID Number
The module’s CANbus Unit ID is defined by a specific System Integer that is dedicated for
this purpose. Please refer to the Help Manual of the Visilogic software for detailed
explanation and setup instructions.
