8
Terminals #15, 16 and 17 are identified by numbers indicating positions of the slide-bar switch that make terminals
functional. All terminals emit + 12V. The UNITROL slide switch is a progressive switch in that it allows only 20
amperes per position, with a total capacity of 60 amperes. If your lighting device requires more current than the slide
switch is rated for you MUST use an external relay, such as a solenoid, to provide higher current to the device. Use
the slide switch to activate the relay. The slide switch will activate the siren when moved to position 3 if the red
power wire, labeled SIREN also has power applied and the MODE switch is in a siren position (WAIL or YELP).
SECTION V
FACEPLATE OPERATION / CONFIGURATION
SW1
SW2
SW4
SW3
SW6
SW5
TouchMaster Delta auxiliary push button switches
Accessory switch connections provide a 12-volt output. Hook the power connection of the auxiliary device to the
terminal that corresponds to the switch output terminal that operator would like to activate. (See illustration on next
page). Switches 1,5 and 6 can be configured as a momentary or latching switch with a 12-volt output. Switch 6 can
be set for either ignition or battery controlled. (See Top Relay Board illustration for jumper configuration) Connect
the red 12ga. wire (marked ACCESS) to battery via a circuit breaker. This wire supplies power for the auxiliary
output device circuit. Connect the yellow 16ga. wire to an ignition-powered circuit.
WARNING LIGHT CONNECTIONS
Summary of Contents for UTMD
Page 7: ...7 TOP RELAY BOARD ...
Page 9: ...9 ...
