KERBEROS POWER
5
2. CONTROL MODULE
Temperature
of water
Device
status
Setting
button
Button
on/off
Communication
connector
SET mode: When pressing the SET key and holding for more than 3 seconds,
the line titled Temperature blinks, repeated pressing SET increases the set
temperature. After reaching the maximum temperature value and further
pressing SET the cycle jumps again to the minimal temperature. To save the
set temperature, hold down SET for 3 seconds again. After that the actual
temperature in the tank is being displayed .
1. The temperature is displayed and set in five discrete steps.
Display mode: The LED line titled Temperatures displays actual temperature
of water in the tank. The temperature is displayed in discrete values, at
temperatures up to 40°C inclusive 1 LED is lit, at a temperature in the range of
41 to 50 ° C inclusive 2 LEDs are lit, etc.
2. LEDs called Status indicate whether LED Heating, thermostat sensor faults
and temperature fuse are active. If there is a fault on the temperature fuse
sensor or the fuse is activated, the Fuse Err LED is lit. If the thermostat
temperature sensor fails, the LED Temp Err lights up. If an EEPROM error
occurs, General Err LED is on.
3. For turning the heating On / Off use the On / Off button. When the heating
is on, the On / Off button is backlit.
EN
