- 4 -
USE OF TIMER
1. Regulate the time of timer according to the clock by turn it
Clockwise(DO NOT TURN IT COUNTER CLOCKWISE)
2. The timer has a small swich,the function is as follow:I=Unit is always On;
=Timer function is ON
3. Set the timer to
position.There are 96 small plastic pins on
the timer,each correspond to 15 minutes interval.Push ourward
the pins corresponding to the time you want the heater to turn ON and push inward the pins
corresponding to the time you want the heater to turn OFF
CAUTION:
A. Do not use the timer function unattended.
B. The heater will not operate if timer is set to the
position and the pins are not
Activated according to the times required.
C. If the heater looses its electricity supply, e.g. Switched off at the mains socket or in the even of a power
failure, the time should be reset after the power on again.
4. The pilot light will be on when the timer is set to ON position or the timing function is activated.
USE OF FAN HEATER
If you want to fasten the speed of heating efficiency when you turn on the unit power,you can just push
the fan heater switch “ON”, the room temperature will be raised in high speed. Push the fan heater
switch”OFF”, the fan heater power will be off immediately.
INSTRUCTIONS FOR USE
1. Before using the heater, make sure that it is on a flat and stable surface, damage may occur if it is
placed on an incline or decline.
2. Set all the controls to OFF position and insert the plug into a socket-outlet with well grounded. Be sure
that plug fits firmly.
3. Rotate the thermostat knob clockwise to MAX position and switch the heater on as follow: the switch I
for low heat, the switch II for medium heat and both switches on for high heat.
4. When your room reaches the desired temperature, now slowly rotate the thermostat knob counter
clockwise until the pilot light goes out. The thermostat can now be left at this setting. As soon as the room
temperature has dropped below the set temperature, the unit will switch it self on automatically until the
set temperature has been reached again. In this way the room temperature remains constant with the
most economical use of electricity.
5. If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the
temperature, or counter clockwise to lower it.
6. This heater includes an overheat protection system that shuts off the heater when parts of the heater
are getting excessively hot.
