6. Tap on
Unpair
. Tap the back arrow button to undo if necessary.
Note
: On an Android 4, tap the pattern to the right of SUPRA-XXXX to unpair.
iPhone or iPad:
1. From the main screen, go to
Settings
.
2. Select Bluetooth (should be ON).
3.
Locate the SUPRA-XXXX and tap the “
i
” to the right of it.
4. Select
Forget This Device
.
Note
: It is a good practice to reboot the Bluetooth device or phone before trying to pair again.
BlackBerry:
1. From the main icon screen, select
Options
(or
Settings
).
2. Select
Bluetooth
.
3. At the top it will say “Bluetooth: Enabled OR Disabled.” To enable if it is disabled, press the menu button
and select
Enable Bluetooth
.
4. On the Bluetooth: Enabled screen, highlight the “Supra-xxxx” for the eKEY Fob.
5.
Press the
menu
button.
6. Select
Delete Device
.
7. Select
Delete
where it says “Delete Supra-xxxx”?
8. Back out of the Options or Settings application.
eKEY Fob WITH bumps
If you have the eKEY Fob WITH bumps, reset the eKEY Fob to unpair it.
Power on the eKEY Fob by pressing
and holding the power button until the green light flashes. Then press the power button five times within 10
seconds. The green light will flash quickly several times and the eKEY Fob will turn off when it is successfully
reset.
Q. When should I change the battery in the eKEY Fob?
A.
The LED light on the eKEY Fob will blink red when the battery is getting low. When the LED first blinks red,
the Fob should be able to perform about 100 more operations. The low battery light may be intermittent when
the battery is starting to get low, but as the battery runs down it will blink red more frequently until it blinks ev-
ery time the Fob is used.
Note
: The eKEY Fob WITHOUT 3 bumps on the back requires two CR2016 batteries and although it will func
-
tion with one battery, the LED will blink red if it only has one battery. If a user has recently changed the battery
on an eKEY Fob without 3 bumps on the back and the LED is blinking red, verify that it contains two batteries.
Q. How do I change the battery in the eKEY Fob?
A.
The eKEY Fob WITH 3 bumps on the back (eKEY Fob 3.1) requires one CR2032 battery. The eKEY Fob 2
and eKEY Fob 3 require two CR2016 batteries.
1.
Insert the tip of a flathead screwdriver into the notch on the side of the eKEY Fob and turn to open the
case.
2.
Carefully slide out the two CR2016 batteries and replace them with the positive (+) polarity facing up on
both batteries.
3.
eKEY Fob WITH 3 bumps: Carefully slide out the CR 2032 battery and replace it with the positive (+)
polarity facing up.
4.
Align the cover and press firmly to close.
The eKEY Fob 1 uses two AAA alkaline batteries. Use a Phillips screwdriver to remove the battery cover from
the back of the fob. Remove the existing batteries and replace with two new batteries, matching the polarity
shown on the battery compartment. Replace the cover and the screw.
4
