background image

© 2019 UTC Fire & Security Americas Corporation, Inc.                             1 / 2 

P/N 1038436 • REV C • ISS 16JUL19 

 

5500 Moisture Detection Series Installation 
Instructions 

Introduction 

The 5500 Moisture Detection Series is designed to respond to 

the presence of water and other nonflammable conductive 

liquids. It is connected in the closed loop of an alarm system. 

You can use up to four surface-mount 5515 sensors with the 

5501 moisture processor. 

You can use the processor with any closed loop control panel, 

dialer, or wireless transmitter input circuit. The processor 

comes with internal lithium batteries with an anticipated life of 

10 to 15 years. The processor provides flexibility in mounting 

with no need for an external power source and minimal 

required wiring.  

Operation 

A time delay circuit is provided to reduce the chance of false 

alarms. The processor requires the presence of moisture for 

ten seconds before going into alarm mode. It will stay in alarm 

mode until the moisture is removed from the sensor. When 

tripped, the LED will flash at two-second intervals until the 

sensor is dry. Optical coupling between sensor input and 

processor output circuits provides isolation from ground. 

Installation 

To install the series, do the following: 

1.  Insert a small, flat-bladed screwdriver in the slot at the top 

or bottom of the processor and pry the cover off the base. 

2.  Mount the processor using the mounting holes shown in 

Figure 1 below. 

3.  Mount the 5515 sensors to any surface and in any 

position, using screws or double-sided tape. 

Wiring 

Wire the sensors in parallel (Figure 1 below). You do not need 

to observe polarity. The connection for output on the 

processor, however, is polarity sensitive. Trigger the processor 

and allow the control panel, dialer, or transmitter to operate to 

verify the connection. 

Testing 

Press the test button (Figure 1 below) for 15 seconds to 

simulate the presence of water and activate the processor (the 

LED will flash). Release the button to restore the processor to 

normal operation. 

Figure 1: 5500 moisture detection series 

 

 

Reviews: