UAV 190 B2
■
6
│
GB│IE│NI│CY
Clearing a material blockage
●
Move the switch
to the “REV” (“reverse”) position if the paper being
shredded causes a blockage.
The appliance now goes into reverse and the paper that is being shredded
is ejected.
●
Pull the paper out of the appliance, then set the switch
to “AUTO”.
●
The appliance is now ready for use.
NOTE
►
Reverse mode is solely for clearing paper jams. Do not use it for removing
documents that are already half shredded and are not causing a jam.
Switching the appliance off
●
To switch the device off, push the switch
to the “OFF” position.
●
If you do not intend to use the appliance for an extended period, remove the
plug from the power socket.
Note regarding overheating of the appliance
If the appliance overheats due to overloading, the overheat LED
lights up as
soon as a paper sheet touches the contact which starts the cutting process. The
appliance stops.
CAUTION!
►
Remove the power plug from the wall socket to avoid unintended restarting
of the appliance.
●
Empty the container.
●
Allow the appliance to cool until it has cooled to room temperature.
●
Put the mains plug back into the socket.
●
Switch the appliance on by moving the switch
into the “AUTO” position.
Summary of Contents for 327170 1904
