13
(While the vehicle is running, the “minutes” digit on the LCD screen will flash and the will
indicate countdown timer based on the 5, 10, 20 or 30 minute run time set up by your
installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down.
(When the unit shuts off the countdown timer will turn off and the transmitter will play a
melody.)
NOTE: The Remote Start Unit will not start the vehicle if any one of the following
conditions exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the “OFF” position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”.
SAFE START (Child safety mode)
Factory default is set to press the
button once on the transmitter to start the vehicle.
You can program this feature to eliminate an accidental remote start:
1. The user presses the transmitter buttons
twice within 3 seconds to start the vehicle.
Or 2. The user presses the transmitter
and
buttons at the same ti me to start the
vehicle.
NOTE: Contact your installing dealer to activate this feature.
B.
OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE
START:
To operate the vehicle while the engine is running from the remote start,
1. Insert the ignition key and turn it to “ON” (not the start) position.
2. Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will
shut down.
C.
TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from
the ignition. This feature is useful for occasions when you wish to exit and lock the
vehicle for short periods of time, but would like to leave the motor running and the
climate control on.
1. Before turning off the engine, press the
button once on the transmitter and the
Siren chirp 1 times to confirm enter.
2. Turn the ignition key to OFF position. (The engine will stay running.)
