MS860 WiFi Manual
INTRODUCTION
CHARGING THE SCANNER:
Prior to performing any operation with the scanner, make sure it has
been fully charged.
8
If the scanner is not to be used for a long period of time, it is recom-
mended that you turn off the battery power of the scanner. Use an
unfolded paper clip to push down the internal power on/off switch,
located inside the round hole on the yellow laser warning label of the
scanner (see page
5
). You will feel a ‘click’ when the internal switch is
moved up to the “OFF” position or when the internal switch is moved
down to the “ON” position.
To
e
nsure that the scanner has been switched off, press the scanner’s
trigger and make sure that the scanner’s LED does not glow red.
Manufacturer’s Suggestion:
A complete charging process takes about 4 to 5 hours, during which the
cradle’s battery charging LED will glow red. After charging is complete
the battery charging LED will remain a steady green. When charging
the scanner for the first time, make sure the scanner remains on the
cradle until after the battery charging LED changes from red to green.
To Charge the MS860:
Simply place the MS860 into the MS086 Charging Cradle. Make sure
the MS086 Cradle is plugged into an available electrical outlet via its
Power Supply.
When the trigger is pressed and a scan laser line is not visible (
do
NOT look directly into the scanner
), the scanner has no power.
Make sure the scanner is not merely switched off.
To charge the scanner, place the unit into the cradle. The battery
status LED on the cradle will glow red, indicating the charging
process has begun.
2.
During operation, a flashing red scanner LED indicates the scanner
has low power.
1.
How to determine if the scanner needs recharging:
