12
www.csunitec.com
Original instructions VARILEX
®
1802 HT
EN
11. Switching on and off
Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
Avoid inadvertent starts: always switch
the tool off
when the plug is removed from the
mains socket or if there has been a power cut.
The machine must not be allowed to draw in
additional dust and shavings. When
switching the machine on and off, keep it away
from dust deposits. After switching off the
machine, only place it down when the motor has
come to a standstill.
In continuous operation, the machine continues
running if it is forced out of your hands.
Therefore, always hold the machine with both
hands using the handles provided, stand
securely and concentrate.
Torque activation (with dead man‘s lever):
Switching on:
See page 3, figure E1.
Slide the trigger switch (A2-4) forwards and
then push the trigger switch upwards.
Switching off:
Release the trigger switch
(A2-4).
Continuous operation:
Switching on:
See page 3, figure E2.
Switch the machine on as described above. Now
slide the trigger switch (A2-4) forwards again
and release in the front position to lock the
trigger switch (continuous operation).
Switching off:
Push the trigger switch (A2-4 )
upwards and release.
12.
Troubleshooting
The electronic signal indicator (A2-1)
lights up
and the load speed decreases.
There is too much load on the machine!
Run the machine in
idling until the electronic signal indicator switches
off.
The machine does not start. The
electronic signal indicator (A2-1)
flashes.
The restart protection is active.
If the mains plug is inserted
with the machine switched on or if the power
supply is restored following an interruption, the
machine does not start up. Switch the machine
off and back on again.
13.
Maintenance
Disconnect the mains plug from the machine
before starting any maintenance work.
It is possible that particles deposit inside the
power tool during operation. This impairs the
cooling of the power tool. Conductive build-up
can impair the protective
insulation of the power tool and cause electrical
hazards.
The power tool should be cleaned regularly,
often and thoroughly through all front and rear
air vents using a vacuum cleaner or by blowing
in dry air.
Prior to this operation, separate the power tool
from the power source and wear protective
goggles and a dust mask.
1-800-700-5919 (US/CA)
www.csunitec.com
+1-203-853-9522 (Intl.)
