Unitec 10923, Original Operating Instructions, Page: 26 / 81

26
This impact wrench is equipped with a rocker switch with which you can switch
from rotation to the right to rotation to the left.
• Put the mains plug (2) into a suitable mains socket.
• Select a suitable socket spanner. When attaching it, make sure that the socket
spanner sits fi rmly and securely on the socket spanner holder (5).
• Place the tool fi rmly on the fi xing element to be worked on (bolt or nut).
• For rotation to the right (clockwise, for tightening the fi xing element), push the
rocker switch to the rotation to the right position (F) (3). Before use, check that
the direction of rotation is correct.
For safety reasons the torque is restricted to 100 Nm in rotation
to the right. Please tighten wheel bolts with a torque wrench and
a torque of about 120 Nm. We would like to point out that wheel
bolts must be tightened again after the vehicle has been driven
about 50 km. Check that the wheel bolts are fi rmly seated.
• For rotation to the left (anticlockwise, to loosen fi xing elements) push the
rocker switch to the rotation to the left position (R) (4). Before use, check that
the direction of rotation is correct.
• Release the rocker switch (3 or 4) to stop the tool.
• Pull the mains plug (2) out of the mains socket after you have fi nished working.
6.2 Switching on/off
1
10923_Schlagschrauber_BA_141205.indd 26 05.12.14 11:04