Unit UEK-274, Instruction Manual

Page: 9 / 20

9
Electric kettle | UEK-274
ENGLISH
should not be a cause for alarm.
• While boiling the kettle, the Water Level Gauge (4) might fog up, cover with
steam from the inside, that is absolutely normal, in a while the steam will go
out. That is not the case of breakage.
• Remove the kettle from the Power Base (6) before attempting to pour.
• When filling or carrying the kettle, do not lift it backwards, as this may allow
water to pass through the steam aperture on to the control area. If this hap-
pens, the kettle indispensably dried before the next use.
• To avoid the risk of splashing, pour slowly and do not over tilt the kettle.
Misuse
• Before turning on the kettle to make sure that there are sufficient water (not
less 0,5 L). Strictly prohibited to turn on the kettle when water below the min-
imum level, or the kettle is empty. This can lead to rapid failure of the heating
element.
• If the kettle is accidental switch on when it does not contain sufficient
amount of water, a boil-dry device will automatically switch it off. Wait until
the kettle cools down before filling, as the element will be hot and spitting
may occur.
AUTO SWITCH OFF FUNCTION
This function is made to protect the kettle from overheating, or switching with-
out water. It will operate if the kettle Is s switch «ON» when there is insufficient
amount of water inside the kettle (the water level in the kettle below the «MIN»
mark). If this should occur, switch the kettle off and remove the power cord from
the power outlet. Allow cooling for 10 minutes then refilling with cold water and
reconnecting to the power outlet.
CARE AND CLEANING
• Always remove the kettle and the Power Base (6) from the socket and allow
the appliance to cool.
• Wipe the exterior of the kettle and the Power Base (6) with a damp soft cloth.