Unit UEK-274, Instruction Manual

Page: 8 / 20

8
Electric kettle | UEK-274
ENGLISH
Filling
• Remove the kettle on the Power Base (6).
• Open the Lid (2) and fill the kettle via the Lid (2) aperture.
• Watch the level of water on the Water Level Gauge (4). You must boil at least
two cups of water, but the water level must be below the «MAX» mark.
• Do not overfill the kettle. If the kettle is overfilled, there is a risk that boiling
water may be ejected.
• Close the Lid (2) and press it down. Check, that it is fully closed; otherwise, the
kettle may not switch off when it is boiling.
Switching on
• Checks that the Switch (5) is in the «OFF» position (lift the kettle from the
Power Base (6) and set it down again).
• Plug the Power Base (6) into the wall socket. If necessary, switch it in to the
socket. Gently put the kettle on Power Base (6), taking care not to spill any
water.
• Press the Switch (5) down. The Indicator Light (7) will light up, and the kettle
will start to heat.
Switching off
• When the water has boiled, the kettle will switch off automatically. The Switch
(5) will return to the «OFF» position and the Indicator Light (7) will blink off.
• If you need to switch the kettle off at any time before the water is boiling,
simply press the Switch (5) to «OFF» position. The Indicator Light (7) will blink
off.
Points to note
• When you lift the kettle from the Power Base (6), you may see moisture on the
surface of the Power Base (6). This is due to the fact that when the automatic
switch-off of the kettle is actuated, part of the steam inside it leaves through
the special holes in the body of the appliance. This is perfectly normal, and