Unit UBS-2210, Instruction Manual

Page: 9 / 24

9
SCALES | UBS-2210
ENGLISH
orie recommendation. Then the scales will show these results 5 times and
automatically shut down.
During the determination of your body fat percentage you will see an analysis of
the measurement results in the form of series of vertical symbols. This is given
for indication of your Fat percentage level, telling where your fat level standing is
comparing to the statistics norms. Whether you are considered as underweight,
normal, or overweight. You can take this indication as a reference data of your
condition.
NOTE: Each time you press the «SET» button you can start the measurement again (including changing
the settings of the previous user) in accordance with the above points.
WEIGHT MEASUREMENT
5. To activate the scales click on the segment of the working surface. After a
few seconds the value «0,0 kg» will appear.
6. Stand on the working surface gently (do not jump on the scales). As son as
you step on the scales there will be the weight indicator on the display (first
time it will be increasing until it fixes on the exact value). After a few sec-
onds the scales automatically turns off.
MEASUREMENT ERRORS
If there are errors during operation the display shows «Err». In this case wait
until the scales is turned off to start the measurement again, whether look if the
batteries are installed correctly. The list of possible defects is given below:
1. All symbols are lit at the same time. This happens when the scales are
switched on and indicates that the device is in good working order.
2. Err – : the maximum load of the scales has been exceeded.
3. Lo – : the battery is re-energize. Install new batteries.
4. Errh – : the maximum possible for these scales body fat content is exceeded.
5. Errl – : the body fat content is too low.
6. [ – : leave the scales and wait a few seconds. Repeat the weighing again.