Unisys UDS2265+, Operator'S Manual

Page: 24 / 144

Settings
This section describes how to set the tear position, the first printing line, the print head gap as
well as the font selection and the character density.
➤
Setting the tear
position
If the tear position of the paper is not aligned with the tear edge of the top cover of the printer,
you can adjust it.
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key. The printer performs a form feed.
Press the
<
(2) or
>
(3) key to move the perforation to the desired position.
Confirm the input by pressing the Set (1) key.
Confirm the input again by pressing the Setup key. The printer is reset to the initial
status.
The correction made – a maximum of approx. 2.5 cm (1") in each direction – will be retained
after switching the printer off.
Adjust Paperway
Menu Char
Online
Setup
2 1 3 4
TOF
Head Tear
Online
Setup
2 1 3 4
TearAdj= 0/72" *
Set
< > Exit
Online
Setup
2 1 3 4
Settings Quick start guide
22