Unist 4210 Series, Operation Manual

Page: 14 / 34

6
Figure 15: Sliding horizontal bars into clamps
3. Slide a bar clamp on the vertical bars, one for each
horizontal bar in the mount. When the clamp is at the
desired height, tighten the clamp on the vertical bar.
4. Slide the horizontal bars into the clamps on the
vertical bar and tighten.
5. Attach the base plate to the mount, and tighten the two
set screws.
6. Stand the mount up, so it is standing on the base
plates.
7. Attach the nozzles to the nozzle mounting clamps.
a. Slide the stainless steel sleeve into the bar clamp.
b. Insert the 1/4-20 bolt from the bottom of the
mounting clamp, through the sleeve, into the nozzle
body, and tighten until the nozzle is secure.
c. Mount the assembly where desired, and adjust the
angle and position of the nozzles by loosening the
bar clamp on the horizontal bar, and sliding or
rotating the nozzle as needed.
Installation
Figure 14: Sliding on the bar clamps
Figure 16: Attaching the base plates
Figure 17: Attaching Low Volume Spray Nozzles
Figure 18: Inserting sleeve & bolt