5
Modular Mounting System Assembly
Mounting the nozzles using the modular mounting
system requires three items:
1. The modular mounting kit (PN 301409-WW-HH, where
WW is the length of the horizontal rods in inches and HH
is the length of the vertical rods in inches).
2. A bar clamp and nozzle stud kit, one for each nozzle to
be mounted (PN 301596). This kit includes a 1/4-20 x 3/4”
SHCS bolt, a stainless steel sleeve, and a bar clamp.
3. The Low Volume Spray Nozzle(s) to be mounted.
When you are assembling the modular mounting kits,
you will need the following tools:
• A 3/16” Allen wrench for bar clamps
• A 3/32” Allen wrench for the set screw in the
base clamp
Note:
Assembly is easier if you do it with the mount
lying flat, then stand it up when it has been assembled.
1. Lay out the pieces, ensuring you have the vertical and
horizontal bars separated and matched.
2. Slide the nozzle mounting clamps onto the horizontal
bars. The number of clamps on each bar is dependent
on your specific nozzle arrangement. When the clamp
is at the desired position, tighten the clamp on the
horizontal bar.
Installation
Low Volume
Spray Nozzle
Vertical
rod
Horizontal
rod
Nozzle
mounting
clamps
Bar clamp
Base plate
Stainless
steel sleeve
1/4-20 x
3/4” SHCS bolt
Figure 11: Complete modular mounting system
Figure 13: Sliding on the nozzle mounting clamps
Figure 12: Laying out the pieces
Summary of Contents for 4210 Series
Page 1: ...Low Volume Spray Nozzles Operation Manual...
Page 6: ...Identifying Symbols Caution ISO 7000 0434B...
Page 8: ......
Page 33: ...25 Notes...