10
2. INSTALLATION
2-1. Initial Inspection
This instrument was carefully inspected both mechanically and electrically before
shipment. It should be physically free of damage. To confirm this, the instrument
should be inspected for physical damage in transit. Also, check for supplied
accessories.
2-2. Connecting AC Power
This instrument requires 230V AC (50-60 Hz) power socket with protective earth
contact (PE-contact). If is available only a power socket without PE-contact (so a
2-conductor ac power) then a power socket with PE-contact must be installed
before or the appliance should be provided with a PE-screw-terminal which is not
soluble by hand and not soluble before 2-conductor power lines.
CAUTION
THIS INSTRUMENT IS SET TO AC 230V. BEFORE POWERING ON THIS
INSTRUMENT, MAKE SURE THE VOLTAGE OF THE POWER SOURCE IS AC
230V.
2-3. Cooling and Ventilation
No special cooling and ventilation is required. However, the instrument should be
operated where the ambient temperature is maintained.
2-4. Position
This instrument is built as a bench-type instrument with rubber feet and tilt stand in
place. Stand-up angle can be adjusted by rotating angle of carrying handle.
2-5. Warming-Up
Allow more than 20 minutes for the unit to warm up so that it is stabilized and
ready for use.
3. OPERATION
www.
.com
1.800.561.8187
