Unison Research
Unico 150
14
3.
CONNECTION TO THE MAINS
The
Unico 150
is set at the factory to the appropriate mains voltage of the
country it will be shipped to.
IMPORTANT! The voltage setting may not be changed by the user.
Never connect the
Unico 150
to AC mains if the local voltage doesn’t
match the value indicated on the rear panel!
The mains fuse is located in the fuse-holder integrated in the IEC mains
socket and inside the amplifier.
IMPORTANT! Always replace fuses with new ones of the same type
and value.
4.
OPERATION
SWITCHING ON AND WARM-UP
WARNING! Only s
witch on the
Unico 150
after all the
connections have been made and checked.
Before switching on, ensure that the volume control is at zero (fully
anti-clockwise), and allow it to remain in that position until the
initial automatic start-up phase is complete.
Just after switching on, the
Unico 150
automatically starts a warm-
up phase, and the front panel LEDs – between the input selection
and volume knobs – blink. During this phase the output stages are
disabled.
The working temperature for the tubes is reached less than 40
seconds after switching on, but best results will be obtained after at
least 10 minutes of warm-up.
Summary of Contents for Unico 50
Page 1: ......
