draw patters using the TMP if you have installed MS Paint ,ScreenPen or
other Paint software.
11. Rarely but possible if two or more
iPazzPort
are within a close proximity the
units may get confused. In that situation you need to run an ID Code
Verification procedure. This is very simple process. Please unplug all the
iPazzPort
USB Adaptors from their respective computers and then power
off all of the
iPazzPorts
. Then take any pair which of
iPazzPorts
and USB
Adaptor to begin ID Code Verification procedure. First turn on your
iPazzPort
and then re-insert the USB Adaptor into a vacant USB port. Now
simultaneously press the Left Mouse Button as indicated by arrow 12 above
and the RF key and indicated by arrow 9 above until LED 3 begins to flash
slowly. Immediately release both keys. You should see LED 3 and LED 5
flash rapidly for about 5 seconds. If you have observed this then you have
successfully completed ID Code Verification.
After completed ID Code Verification, use mouserate.exe to confirm the
iPazzPort
works fine. Move TMP on Mouserate window, you read the
average is about 70 or above, as more as better. If it is below the value,
please repeat to adjust.
After you have completed the ID Code Verification the
iPazzPort
will
immediately enter power save mode. In order to wake the unit please
presses any key.
If you find that LED 3 & LED 5 are flashing slowly after your attempt at ID
Code Verification then it means you have not successfully completed the
pairing of the
iPazzPort
with the USB Adaptor. You must then repeat this
process until both units pair together. This process usually takes one time.
Unisen recommends that you are near your computer during this process.
The
iPazzPort
will operate in parallel with your existing keyboard and
mouse. Any of the keyboards or mice will operate equally and