UNIS TICKET DOME, Operation Manual

Page: 26 / 41

Treasure Dome RFID Prototype Manual
11/15/2019
25
7. TROUBLESHOOTING
7.1 Common Problem
Please confirm whether every connector connected tightly.
Symptom Possible Cause Recommended action
Game will not
start
Frame assembly connector is
loose.
Plug the connector tightly.
Frame assembly fault Contact with UNIS Service.
Power cutting
Circuit protector make power SW
in cutting state
Turn on power SW again. If appeared
again and again, machine has
anomaly. Please contact with UNIS
Service.
Game will not
coin up
Coin mechanism fault or sample
coin not installed.
Change coin mechanism or sample
coin.
Coin mechanism signal cable
loose.
Check coin mechanism signal cable
loose.
IO control board no signal. Change IO board.
No sound
Volume set too low. Raise the volume.
Connector loose. Plug in connector tightly.
PCB fault. Change PCB.
Speaker fault. Change speaker.
POT installation error. Install POT correctly.
POT fault. Change POT.
Audio cable problem.
Reconnect the audio cable or change
it.
Driver problem Restart the audio driver.
8. MAINTENANCE & INSPECTION
8.1 Safety Check
Check the points listed before operating the machine. These checks are necessary for safe
machine operation:
1. Test game before operation each day.
2. Conduct monthly routine checks of game components ensure good working condition
3. Check the machine regularly for dust and clean when necessary.
Note: Parts and components require preventative maintenance to maintain proper
operation.
8.2 Handling Precautions
When installing or inspecting the machine, be very careful of the following points and
pay attention to ensure that the player can enjoy the game safely.
Non-compliance with the following points or inappropriate handling running counter to the
cautionary matters herein stated can cause personal injury or damage to the machine
We do not recommend using power tools as they may cause damage.
NOTICE