32
3. Press the knob inward and hold
to activate the electronic ignition.
Note that you will hear a “clicking”
noise. Hold the knob pressed
inward until the oven burner is lit.
Once the oven burner is lit, release
the knob.
In case of power outage, you can manually light the burner by pressing the knob
inward and immediately approach a lighted match to the opening “A” (see the
diagram above).
Never continue this operation for more than 15 seconds. If the
burner has still not ignited, wait for about 1 minute prior to
repeating the ignition.
4. When using the range for the fi rst time or after long period of non-usage, keep
pressing the knob inward for approximately 10 – 15 seconds after the burner has lit
to ensure the gas valve has been accurately primed.
5. Close the oven door slowly and adjust the burner accordingly to the desired
temperature. If the fl ame extinguishes for any reason, the safety valve will
automatically shut off the gas supply to the burner.
To re-light the burner, fi rst turn the oven control knob to the OFF position, wait for at
least 1 minute and then repeat the lighting procedure.
Attention: the oven door becomes very hot during operation. Keep
children away.
MOISTURE
IMPORTANT
If sparking does not occur when the oven thermostat knob is turned on during the
initial attempt to use, or after several days of non-use, it COULD BE the result of
moisture build-up in the ceramic sleeve of the oven electrode. This may happen
in areas with high humidity, or if food having high water content is cooked. This
moisture can be driven out of the ignitor by lighting the pilot and operating the oven
for a few minutes.
OPERATION OF RANGE
(continued)
A
32
Summary of Contents for UGP-24CR W
Page 21: ...21 WALL CLEARANCES continued...
Page 45: ...45 24 WIRING DIAGRAM...
