4
遥控器和飞机飞行控制器的中立位匹配调校方法
Radio system and control panel adjustment guidance
特别提醒
： 调试飞机之前请不要安装螺旋桨，避免危险发生！！
产品适用的电池是：
4S 14.8V 25C 2200
毫安时
-2600
毫安时锂电池
For your kindly reminder: for your own safety, pls do not install the
propeller before you finish adjustment.
Battery specification: 4S/14.8V/25C/2200mah to 2600mah Li-polimer
1:
遥控器各通道请微调到中立位置，各通道大小舵量请调整到正负
100
Trim the transmitter in neutral position, each channel adjusts to plus or minus 100.
2
：按图纸连接接收机到飞控各通道接线，连接机翼各通道连接线，
Connect the receiver to each channel on the control panel.
3
：连接电池，拨动
5
通道开关，将飞机置于固定翼状态，（注意：连接电池后请
保持飞机机身静止状态，不要晃动机身）
Connect to the battery, open channel 5 to make the plane under fixed wing mold.
(Caution: keep the fuselage static after connecting the battery, do not shake the
fuselage. )
4:
断开电池连接
Disconnect the battery.
5
：插上校准线
(
接线图所示
)
Plug to the calibration wire.(As page 3)
6
：再次连接电池
Connect to the battery again.
7
：飞控板上绿色的灯会有节奏闪烁，然后迅速将油门杆和升降杆同时打向
45
度
左下方，飞控上的灯会高频率快速闪动，然后同时松开油门杆和升降杆，校准完
成。
When the green lights on the control panel flashing rhythmically, then quickly lift both
throttle and elevator 45 degrees to the lower left. After the light flash fast, release the