S
tep
4:
Amplifier to Speaker Hook Up
Connect the
black wire with white stripe (-)
from the left speaker to the
green wire
from the amp.
Connect the
black wire without white stripe (+)
from the left speaker to the
brown wire
from amp.
Connect the
black wire with white
s
tripe (-)
from the right speaker to the
dark blue wire
from the amp.
Connect the
black wire without white stripe (+)
from the right speaker to the
orange wire
from amp.
Step 5: Bluetooth Controller Installation
Mount the controller to the handlebars using one of the included mounts.
Run the red (+) wire to battery positive and black (-) to battery negative (or to the vehicle’s chassis where paint has been removed).
Connect the blue remote-on wire to the orange wire from the amp
(from step 3)
.
Connect the included 3.5mm to RCA cable to the
female output on the
Bluetooth controller and connect the other end to the RCA inputs on the
amplifier.
(Red to Red, Black to White)
Step 6: Test and
E
njoy
for a Lifetime
!
You should now be able to test the system. Try a test run with the bike off, then if all is well, go for a test ride with your new tunes!
If you ever have an issue,
remember your system is covered by a complete Lifetime Warranty. So kick back, relax and enjoy your new riding experience!
**If something is not working correctly
or
you have poor or no sound or receive feedback, please re-check all wires, including
remote and
positive
connections and confirm that your system is connected to a good ground. Confirm that no wires are stripped
or melted
and touching metal. If available, also
test the system using a different audio device
.
If you still have issues
, check out our troubleshooting tips under the FAQ & Support section of our website or
initiate a Live Chat with one of our technician for additional assistance (after-hours support via email at [email protected]).
