5. Installation Instructions
Review all instructions as well as important notes located at the end of this section before starting installation.
Step 1:
Mount the Speaker Clamps
Unscrew the allen screws from one side of the clamp to install the clamp.
Mount to your handlebars, highway bars or other location and ensure
all
4 allen
screws on each clamp are securely tightened. The clamps themselves will tighten
to the bar
when the speakers are installed.
Step 2:
Mount the Speakers
Remove the nut and lock washer only and f
eed the
speaker
wire through the clamp
hole
and mount each speaker to the clamp
. Put the lock washer and
nut back on and tighten speaker to clamp.
(Flat washer and lock washer go on the bottom)
. Make sure they are tightly and safely secured
without any
movement
, but do not over tighten. Run the speaker wires down to where you are going to mount the amplifier, being careful to avoid the engine or any
area that could cause heat or other damage to the wire/vehicle or inhibit your driving ability.
Step 3:
Amplifier Power Hook Up
Find a place where you want to mount the amplifier away from direct exposure to the elements such as a tool compartment, under the seat, fork bag,
saddlebag,
windshield bag,
etc. Most places will be fine, but try to avoid areas that could cause overheating (such as places wrapped in foam or cotton).
Take the
BLACK
(-) ground wire and run it to the negative (-) battery terminal
(or to the vehicle’s chassis where paint has been removed)
. Take the
RED
(+) positive wire and connect it to
the
positive (+) battery terminal
.
Take the
ORANGE
remote
-on
wire and
run it to where you will install your
Bluetooth
controller
(
This will be connected in
step 5
when installing the Bluetooth controller).
The system will
turn on and off using the controller.
(It will also turn
Off automatically after 5 minutes when there is no active Bluetooth device connection to prevent battery drain).
(*
*
For non-Bluetooth devices, the orange wire must instead be connected to a switched power source (headlight, tallight, etc).
If orange, black
&
red wires are not connected, system will NOT work.
