Unipulse F701-P, Operation Manual

Page: 102 / 116

91
10 SPECIFICATIONS
91
SP
EC
IF
IC
A
TI
O
N
S
Chapter
10
■
Setting section
Setting method Settings are made by membrane key operation.
Also, settings can be made from a host computer through
RS-485 I/F, etc.
Storage of setting values Stored in F-RAM (nonvolatile RAM)
Protection of setting values Software LOCK of a set value and the calibration value is possible.
Setting items Upper limit/ Lower limit/ Near zero/ Set point 1/ Set point 2/
Compensation/ Over/ Under/ Final/ Comparison inhibit time/
Judging time/ Complete output time (Hold time)/ Weighing
function 1/ Weighing function 2/ Tare setting/ Tare display/
Digital low-pass filter/ Moving average filter/ Motion detection
(Period - Range)/ Zero tracking (Period)/ Zero tracking (Range)/
Total comparison selection/ Total limit (high 4)/ Total limit
(under 5)/ Count limit/ Key invalid/ LOCK/ External input selection/
External output selection/ PASSWORD/ Balance weight value/
Capacity/ Minimum scale division/ DZ regulation value/
Display selection/ Gravitation acceleration/ RS-485 I/F/
Communication type/ RS-485 ID/ Transmission delay time/
Span calibration/ Zero calibration
■
External signals
Source type or sink type selected at order-time.
- Output signals
Output type When each signal turns ON, the output transistor turns ON.
* There is a need to prepare an external power supply.
Number of outputs 4 points
Isolation method Photocoupler isolation
Rated input voltage DC24V
Operating voltage range DC20.4 to 26.4V (ripple percent within 5%)
Max. voltage DC30V
Max. current DC120mA
- Input signals
Input type Contact (relay, switch, etc.) or non-contact (transistor,
photocoupler, etc.) connectable
* There is a need to prepare an external DC power supply.
Number of inputs 4 points
Isolation method Photocoupler isolation
Rated input voltage DC24V
Operating voltage range DC20.4 to 26.4V (ripple percent within 5%)
Load current Approx. 11mA (when 24V DC load)