10
Quick guide
Q u i c k G u i d e
SAVE THE MEASURED
PRESSURE VALUES
If you start in “Sequence mode”, the screen
will inform you about which tire you are sup-
posed to measure.
Use one or both of the air valve buttons on the
pressure handle to reduce the pressure.
Measure the tire pressure on the first tire and
press the
right
button ( ) to save the value.
Then move on to measure the pressure on the
next tire in the sequence.
The tire sequence is defined in the Setup
mode. This is described in ”SEQUENCE SETUP”
on page 19.
RECALL STORED VALUES
From “Sequence mode” press the
left
button ( ) to recall the saved tire pressure
values in “Recall mode”.
The screen will list 4 sets of tires. Depending
on the selected sport, there will be either two
or four tires in each set.
The tires are listed in the same sequence as
selected in Setup mode.
The bottom of the screen will show the current
page and the total number of pages.
UniTire can store values for up to 20 sets of
tires.
Press the
right
button ( ) to go to the next
page.
CLEAR THE STORED
PRESSURE VALUES
If you want to clear the stored values, just
press and hold down the
left
button (
3
) from
“Recall mode”.
TRANSFERRING DATA
From “Recall mode” press the
left
button ( )
to go to “Transfer mode”.
While the transfer screen is active, the
Bluetooth communication is turned on and
running. If the app is active, it can connect to
UniTire and transfer data or settings.
Press the
left
button ( ) to go back to ”Se-
quence mode”
SETUP MODE
To change settings, press and hold the
left
and the
right
button (
3
+
3
) at the same
time to go to Setup mode - either when turn-
ing UniTire on or during normal operating.
For more information about Setup mode,
please see “ENTER SETUP MODE” on page
19.
TURN UNITIRE OFF
Press the
right
button (
3
) and hold it down
to turn UniTire off. When you see “POWER
OFF” in the display, you can release the button
again.
UniTire will also turn itself off if no button is
pressed and no pressure is detected after a
preselected time.
BUILT-IN HELP
When you turn UniTire off and “POWER OFF”
is displayed, you can press the
left
button ( )
before you release the right button, to display
the built-in help.
In help mode, the
right
button ( ) will show
the next help page, and the
left
button ( )
will show the previous help page.
To leave help mode, turn UniTire off.
That’s how easy it is!
If you are ready for
some more advanced features, then read the
Reference Guide in the following section.
