P O W E R I N G T E C H N O L O G Y
UNIPOWER LLC • 3900 Coral Ridge Drive, Coral Springs, Florida 33065, USA • [email protected]
North America: +1 954-346-2442 • Latin America: +1 954-905-1078 • Europe: +44 1903 768200
Aspiro 1U in 2U Enclosure Quick Install Guide - 3
3 AC Input Connections
WARNING!
The power system is internally grounded. Grounding
is achieved through the 3 conductor AC power cord.
CAUTION
Depending on deployment region with regards to
lightning strikes and heavy inductive energy, it is highly
recommended to install AC Surge Protection Class C
at the electrical panel.
AC connectors are situated on the right rear side of the
system as shown below.
4
3
2
1
LOAD
+
_
+
_
+
_
+
_
BATTERY
+
_
AC INPUT 2
AC INPUT 1
SIGNAL
CONNECTIONS
BATTERY
AC
INPUTS
DC
OUTPUTS
+
-
+
-
+
-
+
_
The following breakers for isolating the AC source are
recommended for each input:
120VAC operation - 20A.
230VAC operation - 16A.
4 DC Output Connections
DC output connections are available at the rear,
with connections labeled corresponding to each
load breaker.
Load breakers should be in the OFF position when
connecting the loads,
Mate-N-Lock connectors are used for DC ouptut
connections.
4
3
2
1
LOAD
+
_
+
_
+
_
+
_
BATTERY
+
_
AC INPUT 2
AC INPUT 1
SIGNAL
CONNECTIONS
BATTERY
AC
INPUTS
DC
OUTPUTS
+
-
+
-
+
-
+
_
5 Battery Connections
The battery connections are located at the center
of the rear panel of the system. Ensure that the
battery breaker is in the OFF position.
4
3
2
1
LOAD
+
_
+
_
+
_
+
_
BATTERY
+
_
AC INPUT 2
AC INPUT 1
SIGNAL
CONNECTIONS
BATTERY
AC
INPUTS
DC
OUTPUTS
+
-
+
-
+
-
+
_
WARNING!
Improper handling with batteries can be dangerous.
Please read and understand the information in the
instruction manual Safety chapter before connecting
batteries.
WARNING!
The battery breaker should be in the OFF position.
The battery cables should be connected to the battery
first, then to the system.
Battery cable (ZLH.00254.01) is custom design for
the Aspiro enclosure.
Connect to the battery first and then plug the
connector end into the system battery connector.
Continued on page 4
