1.3 Air hose
Clean the hose with a blast of compressed air
before connecting the hose to air tool. This
will prevent both moisture and dust within
the hose from entering the tool and causing
possible rust or malfunction. To compensate
for unusually long hose ( over 25ft ) the line
pressure should be increased accordingly.
1.4 Sockets :
The tool is used fastening or loosing of
threaded fasteners. The sockets must be of the
impact type with suitable square drive dimen-
sion. Do not use any other type of socket.
1.5 Approved eye protection, mask, hearing
protection and gloves shall be worn when
operate this tools.
1.6 The working place shall be ventilated.
1.7 Release the on-off device in case of air
supply failure.
1.8 Ensure that the power tool is firmly at-
tached when using a suspension device.
1.9 Release the start and stop switch in case
of a failure of energy supply.
1.10 Use only a lubricant recommended by the
manufacturer.
2. Operation method
2.1 On-off switch
The on-off switch is on the inside or
outside of the grip. It is a “ hold-to-
run” type. This tool stops rotation
in a few seconds after releasing the
lever. For the sake of safety, please
ensure it has completely stopped
before touching.
2.2 Torque adjuster :
You can adjust the torque by
rotation the knob. Torque is
indicated by numbers. Lower
number indicates lower output
torque setting and vise versa.
2.3 Rotating direction :
Ensure the direction of rotation
is correct before operation. The
“F” indicates forward and the “R”
indicate reverse. Forward is defined
as clockwise viewed from the
operators position.
3. Maintenance
3.1 Lubrication :
Before connecting the hose, apply 4 to 5 drops of # 60 spindle oil
at the inlet. Use of a thicker oil can lead to reduced performance of
malfunction. Also oil after every 3 to 4 hours of operation.
3.2 Storage :
Avoid storing the tool in a location subject to high humidity. If the tool
is left as it is used, the residual moisture inside the tool can cause rust.
Before storing and after operation, oil the tool at the air inlet with
spindle oil and run it for a short time.
3.3 Ordering service part .
For further operational and handling information or for replacement of
parts and components contact the outlet from where you purchased the
tool or the service division of your company.
