Union INCA3021, Translation Of The Original Operating Instructions

Page: 20 / 67

Transport, setup and acceptance
20
5.2 Ambient conditions
ATTENTION
Ambient conditions during storage and set up.
Observe the stipulated ambient conditions. Contact Union Instruments GmbH if
the process gas analyser has been stored for more than three months or needs to
be operated or stored under ambient conditions other than those specified.
5.2.1 Storage conditions
If condensation water freezes in the process gas analyser, this can cause defects.
Protect the process gas analyser against frost when putting it into storage.
Ambient temperature: -20 - 60°C
Humidity: 0 - 95% relative humidity
Ambient pressure: 700 - 1400 hPa (0.7 - 1.4 bar)
5.3 Set up and connection
5.4 Setup site
The setup site for the process gas analyser must satisfy the following conditions:
•
Clean dry room (with the exception of INCA5000/INCA6000)
•
No direct exposure to sun
•
Protect from climate influences with a heater or air conditioning if necessary
•
Insure a clean, sufficient amount of ambient air for undistorted measurements
•
Ensure that the loadbearing capacity of the wall is sufficient
WARNING
Leaking process gas can pose a hazard and needs to be discharged by the
operator into a safe environment.