Union Instruments CWD2005 SPC, Operating Instructions And Safety Notes

Page: 30 / 63

OPERATING INSTRUCTIONS
CWD2005 SPC
chapter
— page:
5
—6
5.4.1 Setup site
The installation location of the system must meet the following requirements:
•
Observe the requirements acc. to the technical data, especially the ambient
conditions and the IP protection type.
•
clean room
•
protected from direct weather impact and direct sunlight
•
Insure a clean, sufficient amount of compressed/ambient air for undistorted
measurements
•
Ensure that the load-bearing capacity of the environment is sufficient
•
Design sufficient space on the sides for mounting and connecting lines
•
install according to the requirements of explosion protection marking
WARNING
Leaking process gas needs to be discharged by the operator into a safe
environment!
NOTE
The compressed air must be dry and free from dust and oil!
Humid, dirty air will distort the measurement results of the analyser.