Installation & Operation
Installing the CiTO Power UPS is as easy as following the steps shown. Be
aware that the Power Switch must be kept in the “ON” position and all
equipment must be plugged into the Battery Power Supplied Receptacles,
otherwise, the UPS will be disabled and your equipment will not be protected
during a power failure.
1. Inspection
Remove the UPS from its packaging and inspect it for damage that may
have occurred during shipping. If any damage is discovered, repack the
unit and return it to the place of purchase.
2. Placement
Install the UPS unit in any protected environment that provides adequate
airflow around the unit, and is free from excessive dust, corrosive fumes
and conductive contaminants. DO NOT operate your UPS in an
environment where the ambient temperature or humidity is high.
3. Charging
This unit is shipped from the factory with its internal battery fully charged.
However, some charge may be lost during shipping and the battery should
be recharged prior to use. Plug the unit into an appropriate power supply,
then switch on UPS and allow the UPS to charge fully by leaving it plugged
in for at least 8-10 hours with no load (no electrical devices such as
computers, monitors, etc.) connected.
