KONICA MINOLTA MAGICOLOR 4600 SERIES TONER CARTRIDGE REMANUFACTURING INSTRUCTIONS
© 2012 UniNet Imaging Inc. All trademark names and artwork are property of their respective owners. Product brand names mentioned are intended to show compatibility only.
UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]
www.
uninet
imaging.com
7. Install the end cap on the cartridge.
If a seal was installed, thread it through the slot. Set the port drive gear as shown and make sure it meshes properly.
8. Install the three screws and install the label.
9. Remove the screw on the chip. Replace the chip.
