Unimig RazorCut KUPJRRW40, Operating Manual

Page: 9 / 24

9
Front & Rear Panel Layout
Front Panel Layout
Rear Panel Layout
4
3
1
2
5
6
9
8
7
11
12
10
(1) Mains Power LED
(2) Over Current - Thermal Overload LED
a. Abnormal or over current supply - LED ON
b. Overheating of the machine - LED ON
(3) Amperage Control Dial
(4) Torch Fault & Low Air Pressure Alarm LED
a. Short circuit between electrode and nozzle - LED ON and air feeds intermittently
b. No electrode or nozzle installed on the torch - LED ON and air feeds intermittently
c. No shield cap installed on the torch - LED Flashes
d. Low air pressure - LED ON
(5) Arc voltage pilot LED
a. Press the torch switch for arc ignition test - LED ON
(6) Air supply selection switch
a. Set to ON for cutting
a. Set to Select to test air flow
(7) Torch connection (DC-)
(8) Output connector (DC+) connect to the work piece
(9) CNC connector
(10) Primary power input cable
(11) On/Off switch
(12) Air supply connector
(Note: the air pressure is preset at 4bar / 60psi)