19
(17) Fit the remaining front end parts to the
torch neck ready for welding.
Continued Torch & Wire Feed Set Up for Aluminium Wire
(10) Remove circlip from guide tube.
(11) Remove the inlet guide tube from the front end machine euro connector using long nose pliers.
(12) Carefully feed the extended PA liner section into the inlet guide tube hole of the machine euro
connector
(13) Feed the extended PA liner all the way up and over the drive roller
(14) Tighten the torch euro connection to the machine euro connector
(15) Cut the extended liner with a sharp Stanley knife just in front of the drive roller
(16) Fit an Aluminium contact tip of the correct size to match the diameter of the wire being used
(17) Fit the remaining front end parts to the torch neck ready for welding
(11 Remove the inlet guide tube using long
nose pliers.
(12) Carefully feed the PA liner into the
inlet guide tube hole of the torch euro
receptacle
(14 Tighten and secure the torch euro
connector to the machine euro receptacle
(15) Cut the extended PA liner with a
sharp Stanley knife just in front of the drive
roller
(10) Remove circlip from guide tube.
(16) Fit an Aluminium contact tip of the
correct size to match the wire diameter
being used
(13)Take the extended PA liner all the way up
and over the drive roller
Summary of Contents for KMM180
Page 35: ......
