4
•
Never leave your machine unattended during operation.
•
Use only for purposes for which it has been designed.
•
Do not underestimate your abilities and know your limits. Use both hands.
•
Never work under the influence of alcohol or other drugs.
•
Do not use the machine/tool if you feel dizzy or week.
•
Any modifications or improvements to the machine are strictly prohibited. DO NOT USE if you discover
bent part, crack or other damage.
•
Never perform any maintenance during operation.
•
If you see any unusual sign or hear any strange sound, switch off your machine and stop working
immediately.
•
Before use, make sure all screws are tighten securely.
•
Perform maintenance regularly. Before use make sure the device is in good working conditions and
without any damage.
•
Use only original spare parts during repairs.
•
Using extension pieces or accessories not approved by the manufacturer may cause injuries to the
operating personnel.
•
Do not expose to extremely high temperature or direct sunlight.
•
This machine is not design for use in humid environments or under water.
•
if you are not using your machine, store it in a dry and safe place, out of reach of children.
•
If not stated otherwise in this manual, all damaged parts must be repaired or changed.
Laser product
•
Laser product class II. (EN60825-1: 1997).
•
Due to safety reasons it is strictly prohibited to look directly into the laser beam with bare eyes or using
any optical apparatus or lens.
•
Do not aim the laser light at persons or animals. Risk of eye injuries
•
Do not touch the laser lens.
•
Laser pointer is not a toy!
Fine mechanics
•
Never use vise to hold your tool/machine.
•
Protect you device from impact and fall.
Assembly
•
Do not use the machine unless completely assembled.
Battery powered equipment
•
If you are not using your device for long time, remove batteries out. Danger of damages due to electrolyte
spillage.
5
•
Before throwing the packaging material out, make sure no part is left inside. If so, take it out and install it.
Use the part listing for check-up and the installation drawing for guidance.
Installation and mounting - option number 1
•
You may use 3 permanent magnets to secure
the laser light in place. Use only for flat metal
surfaces.
Installation and mounting - option number 2
•
Using 3 screws or self-adhesive tape. Make sure
the pointer is positioned above the work piece
surface.
•
Set the position of the pointer so the laser beam
is aimed at the desired place/spot on the work
piece.
•
Switch the pointer on and make sure that the
laser cross appears where intended.
•
If necessary, correct its position so the beam is
aimed at the desired spot on the work piece.
Battery installation
•
Before changing the batteries, always make sure
that the main switch is in the off position (red
button in the released position).
•
Unscrew the brass battery cover as seen on the
picture.
•
Place the batteries inside the compartment.
Observe the polarity (-).
•
Screw the battery cover back on.
ASSEMBLY
