Sprite Installation and Operator’s Manual
REV D1
Page 18 of 36
8.2.2
Position the ticket stock box(es) behind the Unit in line with the ticket inputs for Bin A and B. Refer to the figure
on the previous page for orientation information. Insert the ticket stock into Bin A face down, staple stub first. As
the stock enters the bin, the motor will begin to run. Release the stock when the bin motor begins to pull the stock
into the Unit. The stock will be automatically positioned for use. Repeat the above procedure for Bin B. Check
the LCD display; if the unit is Offline, place it Online by pressing the
ONLINE/ENTER
push-button.
8.2.3
If the optional Locked Ticket Box was purchased, attach the bin to the rear of the SPRITE printer using the two
thumbscrews already installed in the bin. The Locked Ticket Box can be set up in two different configurations.
First, with the shelf installed in its normal position, the bins can be loaded with two stacks of 500 coupons each,
both of which are secured when the door is closed and locked.
8.2.4
The second option is with the shelf removed (it can be stored upside down on the bottom of the box with the lip up
and to the rear). In this configuration, there is room for a box of one-thousand for Bin A internally secured. A
second, non-secured stock type can be inserted from the top of the bin by sliding the latch forward (toward the
Unit) and opening the flap. Refer to the figure above for routing of the stock for this configuration.
