Multi-Function Sharpener – MFS2
E&OE
© 2017 Unimac
3
Electrical Safety
When using electric appliances, basic
precautions should always be followed,
including the following:
•
To disconnect, switch OFF all controls
("O"), then disconnect rom the
electrical supply.
•
Do not unplug by pulling on cord – to
unplug, grasp the plug an pull.
•
Disconnect the equipment from the
electrical supply when not in use and
before servicing or cleaning.
•
Do not operate any appliance with a
damaged cord or plug, or if it
malfunctions, dropped or damaged in
any way.
•
To reduce the risk of electrical shock,
do not submerge the equipment or
electrical cord in water or other liquid.
•
The tool is double-insulated, meaning
no ground / earth wire is required.
Double-insulation provides additional
safety against injury resulting from a
possible failure of electrical insulation
within the device. Normal electrical
safety precautions must always be
followed when using the tool.
•
Risk of electric shock. Keep all
electrical cables cord connection dry
and off the ground.
•
A residua current device ("RCD")
rated at 30mA or less must be used.
•
If using an extension lead, ensure it is
an approved extension lead suitable
for the power input of the tool. Before
use, inspect the extension lead for
signs of damage, wear and ageing.
Do NOT use the extension lead if it is
damaged or defective. If the
extension lead is on a reel, fully
unwind the lead. Using extension
leads not suitable for the electrical
requirements of the tool or which is
damaged or defective may result in a
electric shock and fire hazard.
Product Use and Care
•
This product is for domestic use only.
•
It is recommended that the tool is
fastened to a solid, level surface.
•
Only use attachments recommended
or sold by the manufacturer.
•
Never operate the tool with a cracked,
chipped or damaged grinding wheel.
Always replace damaged grinding
wheels immediately.
•
Always disconnect the tool from the
electrical supply before changing
accessories or making any
adjustments.
•
Always use protective equipment
including earmuffs, goggles, gloves,
hat and clothing when operating the
tool.
•
Do NOT use an object to slow or stop
the grinding wheel whilst in motion.
•
Ensure that the tool speed does not
exceed the maximum operating
speed of any replacement grinding
wheel.
•
Do not operate the equipment with
any guard or safety device removed.
Ensure that all guards and safety
devices are correctly installed and
adjusted.
•
The warnings, precautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations that
may occur. It must be understood by
the operator that common sense and
caution are factors which cannot be
built into this product, but must be
supplied by the operator.
