Unimac LXG3000 User Manual Download

Page: 14 / 18

Cordless 34° Gas Powered Framing Nail Gun

E&OE

Nailing

Do NOT keep the trigger pulled when the machine is not in use or modify the trigger to

remain pulled after it is released. • Before use, check that the fasteners are loaded correctly

in the magazine, ensure the battery is charged, and that the fuel cell is not empty. • Always hold the tool

firmly and parallel to the work piece so that the fasteners are driven in at 90° to the work surface. • Always

take care to avoid damage to the safety contact tip – do NOT apply force to it when the tool is not ready for

normal operation (nails loaded, battery and fuel cell installed). • NEVER point the tool at any person, animal

etc. Always assume the tool is loaded with fasteners. • Fuel cells contain highly flammable chemicals, at high

pressure. Do NOT use in environments where sparks, flames or other sources of ignition may be present. Do

NOT smoke when using the tool or handling fuel cells. • Fuel cell gas and tool emissions are toxic –

ALWAYS use the tool in well-ventilated areas. • Be aware of wiring, plumbing etc that may be pierced or

contacted by nails. Before commencing work, ensure that there is no possibility of contacting live electrical

wiring, gas or water plumbing etc. • Do NOT use the tool if the trigger or any safety guard or mechanism is

not installed or is not operating correctly – have the tool inspected and repaired at an authorised service

centre before using it again. • Fully understand how to safely operate the tool and the various attachments. •

ALWAYS remove the battery and fuel cell cartridge from the tool before performing any maintenance

activities, loading nails, clearing nails jams etc. • Always hold the tool firmly during operation, while allowing it

to recoil away from the work surface as the fastener is driven. If the firing tip is allowed to contact the work

surface again before the trigger is released, an unwanted fastener may be fired. • Do NOT drive fasteners on

top of other fasteners, or with the tool at a steep angle – the fastener may ricochet and cause injury. • Do

NOT drive fasteners close to the edge of the work piece. The work piece may split and allow the fastener to

fly free or ricochet and cause injury. • Do NOT use the equipment for purposes it is not designed for. •

ALWAYS use accessories (nails, fuel cell cartridges etc) that are directly compatible with the tool. • If a nail

jam occurs, clear the jam before using the tool again. • Check operation of the firing tip before each use. • Do

NOT allow your hands, feet or face within 200mm (8") of the firing tip when using the tool. • Follow all safety

precautions recommended by fuel cell manufacturers.

1. Press the safety contact pin (

) against the work piece so the safety contact pin is pushed in.

2. Pull the trigger (

) to fire the fastener.

3. Release the trigger and lift the tool from the work piece so the safety contact pin extends.
4. Repeat 1 to 3 for each fastener.

90°

Work Piece

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC `

UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC UNIMAC