Pneumatic Air Coil Nailer
E&OE
© 2017 Unimac
10
Maintenance
Clean and Inspect the Tool Daily
Caution
: Disconnect the tool from the air supply before cleaning and inspecting it. Correct all problems before
operating.
•
Check the filter of the compressor weekly and switch of the manual valve to drain water and other
contaminants out.
•
Do not soak the tool in cleaning solutions. Such solutions can damage internal parts. The exposed portion of
the small piston rod and the feed hook must be kept clean.
•
Inspect the trigger and safety mechanism to ensure that the system is complete and functional: no loose or
missing parts, no binding or sticking parts should be found.
•
Keep all screws tight. Loose screws can cause personal injury or can damage the tool.
•
Check if there are any worn and damaged parts. If there are any, please replace them immediately.
•
If the tool is used without an in-line oiler, place 5 or 6 drops of air tool oil into the air inlet of the tool at the
beginning of each workday.
Service and Repairs
All quality tools will eventually require servicing of replacement parts due to wear-and-tear from normal use.
Some user serviceable components are described in the
section. All repairs made by local
agencies are fully guaranteed against defective material and workmanship. We cannot guarantee repairs made
or attempted by anyone other than these agencies.
