TECHNICAL SPECIFICATIONS
^While the Germkill Kit and the Sediment Filter have a fixed replacement schedule, you might be required to clean/change
the SF in the interim depending on the quality of your input water. If the External Sediment Filter is not replaced/cleaned
in time (when the blue blinking happens), it may affect the performance of the purifier. Blinking for sediment filter will
occur to clean/replace sediment filter after approximately 132 hours of pump running time. You can either clean SF or call
Pureit helpline to replace filters at a nominal cost.
* Permeate flow rate and recovery are based on standard test conditions and may vary depending on input water quality,
TDS, pressure and life of Filter elements.
*** Input water quality and TDS content are important determinants of output water quality.
**** If input pressure exceeds 30 PSI, please install a company provided pressure reducing valve at an additional cost. If
the pressure is lesser than 10 PSI then you need to buy ‘Pressure enhancing pump’ at an additional cost. Device should
not be installed in a house where input pressure is greater than 60 psi.
###After every 275 hours of pump running time the Germkill Kit needs to be changed. Every 275 hours of pump running
time typically gives 6000 liters of purified water under test conditions of 10 PSI input pressure, 750 ppm TDS and 25 °C
temperature. Any variations from the test conditions will lead to variations in the filtered life.
#### Every 78 hours of Cu Valve running time typically gives 8000 liters of copper enriched water under ideal condition
(10 PSI input pressure, 750 ppm TDS and 25°C temperature).
# Technical specifications are subject to change or improvement without prior notice.
> In case the TDS is >1000 PPM, a company provided anti-scalant is recommended to be installed. This has to be
purchased at extra cost.
>>If the iron content in the input water is more, it is recommended to install a company provided iron filter at an
additional cost.
$ 7.6 to 8 litres in running water conditions.
5
Pureit Copper
+
Mineral RO+UV+MF
Height
~447 mm
Width
~350 mm
Depth
~361 mm
Weight
~9.5 kg
Flow rate*
Up to 24 litres per hour
Storage tank capacity
Upto 8 litres
$
7 -Stage Purifying Technology
Membrane type
Pump type
Diaphragm pump, 24V dc
Thin-film composite spiral wound
% Recovery*
Typically 60%
TDS reduction***
90% (min)
Input water pH range
pH range 6.5-8.5, Temperature range 10°C- 40°C
Rated Power
60 Watts
Pressure rating
10-30 PSI****
Rated Voltage
100-240V AC 50/60 Hz (Device can withstand voltage
fluctuation from 100 to 300 V AC.)
Material of construction for plastic parts Food safe, non-toxic, engineering grade plastics
Length of Power Cord
1.5 metres
Total Dissolved Solids
Upto 2000 mg/lit
Total hardness
500 mg/lit (max.)
Iron
0.3 mg/lit (max.)
Turbidity
1NTU (max.)
Germkill Kit™
Material of construction
Food safe, non-toxic, engineering-grade plastics
Copper Germkill Kit™
Copper Module with Harness – 1 Nos
Germkill Kit™
Pre-Sediment Filter – 1Number Pre-RO Carbon Filter – 1Number
Mesh Filter – 1 Number
Post-RO Carbon Filter – 1Number
Mineral Cartridge – 1 Number MF Membrane – 1 Number
RO Membrane – 1 Number Anti-Scalant Cartridge – 1Number
PP Melt Blown Pre-Sediment Filter, Pre-RO Carbon Filter,
Mesh Filter, Reverse Osmosis Membrane, UV Reactor,
Post-RO Carbon Filter and Micro Filter Membrane
Germkill performance standard
Meets stringent international criteria for
microbiologically safe drinking water – e.g.,
Environmental Protection Agency (EPA), USA
3. COPPER CHANGE
SOLID GREEN
Copper is safe to use
RED BLINKING
Advance alert to change Copper
After every 77Hours and 50 minutes
of Copper DSV running time post
device installation or Copper
replacement.
RED SOLID
Auto-shut off, replace Copper
GKK.
After every 78 hours
####
of
Copper DSV running time, post
device installation or Copper GKK
replacement.
RED, BLUE, GREEN
BLINKING IN SEQUENCE
Electric Fault
4. COPPER RO WATER
YELLOW SOLID
Copper RO water is dispensing
YELLOW BLINKING
Auto-Cleaning Mode,
water cannot be dispensed
RED SOLID
Fault, water cannot be dispensed
5. RO WATER
BLUE SOLID
RO water is dispensing
RED SOLID
Fault, water cannot be dispensed
1. TANK FULL
SOLID GREEN
Tank full
SOLID RED
Low / No input water
2. SF / GKK CHANGE
SOLID GREEN
SF / GKK is safe to use
BLUE BLINKING
Replace / clean SF^
RED BLINKING
Advance alert to replace GKK
After every 260 hours of pump
running time, post device installation
or GKK replacement.
RED SOLID
Auto-shut off, replace GKK
After every 275 hours
###
of pump
running time, post-device installation
or GKK replacement.
LED INDICATOR GUIDE
