USER MANUAL M80
11
The respective accident prevention regulations established by the professional associations are to
be strictly enforced at all times
1. Introduction / Product Package
The voltage tester M80 is universally applicable tester for voltage testing, continuity testing, rotary
field testing and trip test of RCD.
The tester is constructed according to the latest safety regulations and guarantee safe and reliable
working.
The voltage tester M80 is characterized by the following features:
● Designed to meet international safety standards. EN61243-3:2014
● Measurement Category (CAT.) IV 600V, III 1000V
● AC and DC voltage test up to 1000Vac and 1500Vdc with LCD
● Polarity indication
● Single-pole phase test
● Phase rotation test
● Trip Test of RCD
● Continuity test
● Resistance test
● Auto-power ON / OFF
● Torch light
● IP64 (IEC60529)
After unpacking, check that the instrument is undamaged.
The product package comprises:
1 pc Tester M80
2 pcs 4mm test tip adapters
2 pcs CAT III/ 1000V test tip cover
2 pcs batteries 1.5V, IEC LR03
1 pc instruction Manual
2. Safety Measures
The testers have been constructed and tested in accordance with the safety regulations for
voltage testers and have left the factory in a safe and perfect condition.
The operating instructions contain information and References required for safe operation
and use of the tester. Before using the tester, read the operating instructions carefully and
follow them in all respects.
3. Danger of electric shock and other dangers
To avoid an electric shock, observe the precautions when working with voltages exceeding
120 V (60 V) DC or 50 V (25 V) eff AC. In accordance with DIN VDE these values represent
the threshold contact voltages (values in brackets refer to limited ranges, e.g. in agricultural
areas).
The tester must not be used with the battery compartment open
Before using the tester, ensure that the test lead and device are in perfect working order.
Look out e.g. for broken cables or leaking batteries.
Hold the tester and accessories by the designated grip areas only, the display elements
must not be covered. Never touch the test probes.