3.
4.
5.
6.
Once the transmitter has been fully recognized by the operating system the
“On Air” LED on the transmitter will light up indicating the transmitter has
been successfully detected and is now operational.
You can now set the transmitting frequency by setting the “FREQ” DIP switch
on the transmitter according to the following diagram. You should choose a
frequency on which no other commercial station is broadcasting.
Open your favorite music playback application and play something in order to
test the transmitter. Make sure the volume level on your computer is set to
around medium.
Extend the UX300 antenna fully and put it in the upright position. Now tune
any nearby FM radio to the frequency selected and listen to the audio. You
should adjust the volume level on the computer so that you have a distortion
free reception.
Setting the computer volume too high may distort the
transmitted signal.
Note that when the UX300 is connected to your computer it will become your
primary sound card and all audio played back will go to the UX300.
The
UX300 incorporates an audio output jack which can be connected to your
existing computer speakers if you would like to listen to the audio on the
computer speakers at the same time.
106.7
106.9
107.1
107.3
107.9
107.7
107.5
ON
ON
ON
ON
ON
ON
ON
1
1
1
1
1
1
1
2
2
2
2
2
2
2
3
3
3
3
3
3
3
ON AIR
USB
AUDIO OUT
USB FM TRANSMITTER
TO COMPUTER
USB PORT
TO COMPUTER
SPEAKERS
(OPTIONAL)
