INPUTS
The XT Series amplifier allows you to use XLR 3-pin input connector per channel. A XLR female jack for
balanced connections to connect the output signal from a mixer, cross-over or EQ to your XT Series
amplifiers. A balanced connection is recommended for cable runs longer than 20ft. When constructing your
own XLR cables follow the pin configuration described below for proper connections. You may use the two
XLR "Input Thru" jacks to jump a parallel connection to another amplifier or other device. For Example:
Connect a XLR cable to the input of channel one. You may now connect a XLR cable from the channel one
"Input-Thru" jack to the input jack of another amplifier's channel one input. This will reduce the use of "Y"
cables.
OUTPUTS
Binding Post/Banana Plug ( XT-900 & XT-1250 only ) :
Connect your speakers to the binding post outputs
on the rear of the amplifier. The speaker wire may be connected by bare wire (directly connected, usually
for permanent connections), banana plug, or spade connector. Connections are made to channel one and
channel two outputs for Stereo Mode or across the red terminals of channel one and channel two for Mono
Bridge Mode.
Important Notice:
Although a speaker will operate with the positive and negative leads plugged into either
terminal on the amplifier binding post, be sure to plug the negative lead into the black terminal and positive
lead into the red terminal. Ensuring proper polarity will avoid speakers being out of phase that can cause a
loss of bass response.
Banana Plugs:
When connecting your speakers to the amplifier using banana plugs, be sure that the red
and black caps on the binding post are completely screwed in. Insert the banana plugs into the caps of the
binding post, be sure that the banana plugs are inserted securely to avoid the risk of popping out.
Figure
5
Male
XLR
Pin
Configuration
Figure
4
3 Negative (-data)
1
2
3
1 Ground / Return / 0v
2 Hot (+data)
page 7
SET UP
Safety Precautions | Introduction | Front Panel | Rear Panel
|
| Speakon Assembly | Operating Modes | Protection | Amplifier Features | Specifications
Set Up
UNiKA
XT-500 / XT-600 / XT-900 / XT-1250
