Figure
3
page 6
XT-900 / 1250 Rear Panel Control
Safety Precautions | Introduction | Front Panel |
| Set Up | Speakon Assembly | Operating Modes | Protection | Amplifier Features | Specifications
Rear Panel
PARALLEL
STEREO
BRIDGE
SUB
WOOF
NORMAL
FREQUENCY
NORMAL
SUB
WOOF
FREQUENCY
20 Hz
20 Hz
200 Hz
200 Hz
INPUT BALANCE
INPUT THRU
PUSH TO RESET
BRIDGE
MONO
_
+
+
+
_
CH-1
CH-2
CH-2
CH-1
_
OUTPUTS
PINOUT
1+
1-
POS NEG
CH- 2
PINOUT
2+
2-
POS NEG
CH- 2
1+
2+
POS NEG
BRIDGE
1+
1-
POS NEG
CH- 1
CH-1
CH-2
CH-1
CH-2
GAIN
0.775V
26dB
32dB
Made in Taiwan
CAUTION
MINIMUM LOAD IMPEDANCE
2 OHM PER CHANNEL
4 OHM BRIDGE
input power less than 2000W
~220V 50Hz
13
23
29
28
26
25
24
14
15
16
17
18
19
20
21
13
22
30
25. Channel 2 Speakon Output -
Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your
speaker’s Speakon input jack.
26. Channel 1 Speakon Output -
Optional speaker output connections. Use
pins 1+ and 1- of this 4-pole Speakon connector to connect to your speaker’s
Speakon input jack.
27. Bridged Speakon Output (XT-500 & XT-600 only) -
use pins 1+ and 1- of
this 4-pole Speakon connector to connect to your speaker’s Speakon input
jack.
28. Channel 2 Output Jack/5 way Binding Post (XT-900 & XT-1250 only) -
Connect to your speaker’s input jack. Red is positive signal and Black is
negative signal.
29. Channel 1 Output Jack/5 way Binding Post (XT-900 & XT-1250 only) -
Connect to your speaker’s input jack. Red is positive signal and Black is
negative signal.
30. AC Cord -
Plug this cable into a standard 230V wall outlet. Check that the
voltage in your area matches the amplifiers required voltage.
31. Ground Lift Switch (XT-500 & XT-600 only)-
This switch is used to
disconnect the internal ground signal from the amplifier’s chassis ground.
This may reduce the buzz that is caused from an electrical 50Hz/60Hz cycle.
UNiKA
XT-500 / XT-600 / XT-900 / XT-1250
