SIGNAL
SIGNAL
CLIP
CLIP
LIMITER
LIMITER
CHANNEL 1
ON
ON
STEREO
BRIDGE
PARALLEL
ON
OFF
CHANNEL 2
POWER
X-6000
STEREO BRIDGEABLE POWER AMPLIFIER
UNiK A
PROFESSIONAL AUDIO
ON
OFF
SIGNAL
SIGNAL
CLIP
LIMITER
LIMITER
CHANNEL 1
ON
ON
STEREO
BRIDGE
PARALLEL
CHANNEL 2
CLIP
X - 3 0 0 0
STEREO BRIDGEABLE POWER AMPLIFIER
Figure
3
Front Views & Rear Views
Introduction
Unpacking
Installation and Mounting
Rear Panel
Operation
Mode Selection
Protection
Specifications
Front Panel
1. Rack Mounting Ears
- Two front panel mounting holes are provided on each mounting ear.
2. AC Power Switch
- X Series amplifiers have a front-panel main AC power switch.
3. Mode Indicated LED
- Red LED indicates "parallel" Mode, Green LED indicates "stereo" Mode, Yellow indicates
"bridge" Mode.
4. UNIKA Logo and Model No
- X series have 4 type model X-3000/X-6000 (3U model) / X-3000 (2U model).
5. Fan Inlet Grills and Filter
- X Series amplifiers are cooled by two rear-mounted fans. Cool air from front grills are
filtered and flows over the heat sinks and exhausts to back side. Make sure these outlets remain clear to allow
unrestricted air flow.
6. Limiter Switch
- You can select limiter on "on" for limiter working, and another mode is for limiter no working.
7. Input Attenuators
- Two input attenuators adjust level for their respective amplifier channels. In Bridged &Mono
(parallel) Mode.
8. Clip LED
- Illuminates at the clipping threshold. Continuous illumination also indicates that ACL (Active Clip
Limiting) protection circuitry is engaged.
9. Signal LED
- Illuminates to indicate that a signal (above a minimum threshold) is present at the amplifier input, and
that the signal is being amplified.
Front Panel
Figure
4
page 5
1
4
3
2
8
9 7
4
5
6
1
4
3
2
8
9 7
4
5
6
X-3000 <2U MODEL> / X-4000 X-6000 <3U MODEL>
UNiK A
P R O F E S S I O N A L AU D I O
