When connecting your speakers to the amplifier using bare wire, unscrew the red and black caps on the binding
post, be sure not to completely remove or unscrew the red and black caps. Strip back the wire insulation ½”
(13mm). Insert the bare wire into the hole that was revealed by unscrewing the binding post cap. After inserting the
wire into the binding post hole, screw the binding post cap down on the wire. To reduce the risk of shock or
damage to your amplifier, be sure that the wire connected to one binding post does not come in contact with that of
another.
SPADE CONNECTOR : (Figure 10)
When connecting your speakers to the amplifier using spade connector, unscrew the red and black caps on the
binding post, be sure not to completely remove or unscrew the red and black caps. Insert the spade connector into
the binding post and tighten the caps down on the spade connector. To reduce the risk of shock or damage to your
amplifier, be sure that the wire connected to one binding post does not come in contact with that of another.
MONO BRIDGE CONNECTIONS : (Figure 11)
Mono bridge operation connections will follow the above descriptions, however, when operating in mono bridge
operation the speaker connections will run between the two positive (red) leads. Use channel two positive output
terminal for the negative connection and the channel one positive output terminal for the positive connection.
Typical speaker output using bare wire.
Insert bare wire into the binding post and tighten.
Typical speaker output using spade connectors.
Insert bare wire into the binding post and tighten.
Figure
10
page 7
1/5"
13mm
Figure
9
BARE WIRE CONNECTION : (Figure 9)
Important Precautions Introduction
Front Panel Rear Panels
Operating Modes Protection Features Specifications
Set Up
CAUTION
MINIMUM LOAD IMPEDANCE
2 OHM PER CHANNEL
4 OHM BRIDGE
BRIDGE
Figure
11
UNiKA
NA-3600/NA-5600/NA-8600