PARALLEL
STEREO
BRIDGE
SUB
WOOF
NORMAL
FREQUENCY
NORMAL
SUB
WOOF
FREQUENCY
20 Hz
20 Hz
200 Hz
200 Hz
INPUT BALANCE
INPUT THRU
PUSH TO RESET
CAUTION:
MINIMUM LOAD IMPEDANCE 2 OHM PER CHANNEL, 4 OHM BRIDGE
BRIDGE
MONO
_
+
+
+
_
CH-1
CH-2
CH-2
CH-1
_
OUTPUTS
PINOUT
1+
1-
POS NEG
CH- 2
PINOUT
2+
2-
POS NEG
CH- 2
1+
2+
POS NEG
BRIDGE
1+
1-
POS NEG
CH- 1
CH-1
CH-2
CH-1
CH-2
GAIN
0.775V
1.44V
1V
Introduction Front Panel
Set Up Speakon Assembly Operating Modes Protection Features Specifications
Rear Panel
page 5
MX-4500/5500/6500 REAR PANEL
UNiKA
MX-3500/MX-4500/MX-5500/MX-6500
Figure
5
23
19
18
27
15
26
25
24
22
11
14
11
17
21
18. Channel 1 & 2 Speakon Output -
Use pins 1+ and 1- of this 4-pole Speakon
connector to connect to your speakers input jack.
19. Channel 1 & 2 Output Jack / 5-Way Binding Post -
Connect to your speakers
input jack. Red is positive signal and Black is negative signal.
20. Ground Lift Switch (
)
-
This switch is used to disconnect the
MX-3500 only
internal ground signal from the amplifier chassis ground. This may reduce the
buzz that is caused from an electrical 50Hz/60Hz cycle.
21. AC POWER Cord
- Plug this cable into a standard 110V wall outlet. Be sure
that the supplied voltage in your area matches the amplifiers required voltage.
Never plug your amplifier into a wall outlet that does not match the required
voltage of your amplifier, serious amage may occur to your unit.
22. Channel 2 Subwoofer Mode On/Off Switch (3U Models only) -
Turns the
subwoofer mode for channel two on and off.
23. Channel 2 Frequency Adj. (3U Models only) -
This pot adjust the frequency
level sent to your speaker on channel two when using your amplifier in
subwoofer mode.
24. Channel 1 Frequency Adj. (3U Models only) -
This pot adjust the frequency
level sent to your speaker on channel one when using your amplifier in
subwoofer mode.
25. Channel 1 Subwoofer Mode On/Off Switch (3U Models only) -
Turns the
subwoofer mode for channel one on and off.
26. Channel 2 XLR THRU Jack (3U Models only)
- This jack is used to
send a parallel signal from the channel 2 input jack to another device or
amplifier.
27. Channel 1 XLR THRU Jack (3U Models only) -
This jack is used to
send a parallel signal from the channel 1 input jack to another device or
amplifier.
12
16
