INPUTS -
The MT-600Q amplifier allows you to use two types of input connectors per channel, the EuroBlock input connectors and 1/4” TRS
female jack that will accept balanced audio signal. Use these connections to connect the output signal from a mixer, cross-over or EQ to the
MT-600Q amplifier. A balanced connection is recommended for cable runs longer than 20ft. Please follow the pin configuration described below
for proper connections.
BINDING POST/BANANA PLUG:
Connect your speakers to the binding post outputs on the rear of the amplifier. The speaker wire may be
connected by bare wire (directly connected, usually for permanent connections), banana plug or spade connector. Connections are made to
channel one and channel two outputs for Stereo Mode or across the red terminals of channel one and channel two for Mono Bridge Mode; please
follow the same connections aforementioned on the channel three and channel four for Stereo Mode or Mono Bridge Mode.
IMPORTANT NOTICE:
Although a speaker will operate with the positive and negative leads plugged into either terminal on the amplifier binding
post, be sure to plug the negative lead into the black terminal and positive lead into the red terminal. Ensuring proper polarity will avoid speakers
being out of phase that can cause a loss of bass response.
page 5
SET UP
Important Precautions Introduction
Front Panel Rear Panel
Operating Modes Protection Specifications
Set Up
OUTPUTS -
EuroBlock Input Connector
Figure
4
UNiKA
MT-600Q
Balanced TRS 1/4” Plug
Hot (+)
Negative (-)
Ground/Shield
Figure
3
CH 2
CH 4
_
_
_
_
+
+
+
+
CH 1
CH 3