Unika GX-Series, User Instructions

Page: 6 / 20

Made in Taiwan
PUSH TO RESET
CH-2 CH-1
THRU THRU INPUT INPUT
CAUTION
MINIMUM LOAD IMPEDANCE
2 OHM PER CHANNEL
4 OHM BRIDGE
Serial No.:
H-2
C
1+ 1-
POS NEG
CH- 2
1+ 1-
POS NEG
BRIDGE
H-1
C
K
C
O
L
K
C
O
L
K
C
O
L
1+ 1-
POS NEG
CH- 1
LIFT
GROUND
PARALLEL BRIDGE STEREO
MODE
0.775V 1.44V 1V
INPUT
GAIN
~220VAC 50Hz
Figure 3
GX-3000 REAR PANEL
16. Fan Outlet Ports - Cooling air enters the amplifier through the front grills
and exhausts through the fans. Be sure not to block these ports when
installing the amplifier or other associated equipment. Air must flow
unimpeded through these ports.
17. Channel 2 Subwoofer Mode On/Off Switch - Turns the subwoofer mode
for channel two on and off.
18. Channel 2 XLR Input Connector - This is the input terminal of the audio
signal that can be connected to the balanced XLR input connector.
XLR pin setting: Pin-2/signal positive, Pin-3/signal negative, Pin-1/ground.
19. Channel 2 Frequency Adj. - This pot adjust the frequency level sent to your
speaker on channel two when using your amplifier in subwoofer mode.
20. Channel 1 Frequency Adj. - This pot adjust the frequency level sent to your
speaker on channel one when using your amplifier in subwoofer mode.
21. Channel 1 XLR Input Connector - This is the input terminal of the audio
signal that can be connected to the balanced XLR input connector.
XLR pin setting: Pin-2/signal positive, Pin-3/signal negative, Pin-1/ground.
22. Channel 1 Subwoofer Mode On/Off Switch - Turns the subwoofer mode
for channel one on and off.
23. Channel 2 XLR THRU Jack - This Jack is used to send a parallel signal
from the channel two input jack to another device or amplifier.
24. Mode Selection Switch - This recessed, three-position switch configures
the amplifier for Bridge, Stereo, Parallel Mode operation. Amplifiers are
factory-configured for Stereo Mode. See section on Mode Selection for more
information
25. Channel 1 XLR THRU Jack - This Jack is used to send a parallel signal
from the channel one input jack to another device or amplifier.
page 5
2 7 29 33
16 18 26 21 23 30
Introduction Front Panel Set Up Speakon Assembly Operating Modes Protection Features Specifications
Rear Panels
UNiKA GX-3000/GX-4000/GX-5000/GX-7000
25 24
2 8 34